|
|
Program > Wednesday 23 May 2007 |
- Session 4 - Slittomatic & Corematic System
Speaker:
Domenico Cecchini
A.Celli International Inc.
- Slittomatic: Functions and Components
- Hardware & Software
- Slitter Setup from A to Z
- Sensor Check and Adjustment - an insight into correct sensor adjustments and the signs that indicate if it is reading
- A Focus on Counter Knife rotor & Stator Replacement
- Understanding Zero reference
- Offsets - Is it always an offset issue, or is it something else?
- Corematic: Functions and Components
- Hardware & Software
- Troubleshooting: Investigating the causes of badly cut cores
- Slitto Core Alignment
- Set Up Tools to Adjust Cut Depth
- How deep is deep enough? A look at a good clean cut
- Cutting head servo motor coupling replacement and zero positioning
- Presentation - Innovations & Opportunities
Speaker:
Paolo Dini
Sales & Marketing Director
- Acqua: The waterblade winder
- Vision 2006: New generation of Slitter-rewinders
- Slittopack: Smart solutions in roll handling and packaging
- Corematic²
- Session 5 - Neck-in Management system:
Speaker:
Francesco Alberti
Automation Engineer
- Understanding Neck-in Management
- The Positioning Rationale
- Defining a Slitting Recipe
- Knife life Management System
- Neck-in Management System
- Troubleshooting
- Practical demonstrations:
- How to create a slitting recipe
- Restoring knife off-set
- Roll edge: how to cut the right spacer
- Managing variable spacers
- Spacerless operation
-
Question time
- Review of sessions : Summary & Question Time
Speakers:
All
|
 |
|
|
|
