|
|
Program > Tuesday 22 May 2007 |
- Session 1 - Winding & Rewinding Process
Speaker:
Francesco Alberti
Automation Engineer
- Definitions: Torque, Nip, Tension
- Winding & Rewinding Fundamentals
- Reel Defects: Cause and Effects
- How to Make a Good Roll
- A Focus on Productivity
- A.Celli's System: Tips & Tricks
- Session 2 - Safety: Do it, but do it safely!
Speaker:
Simone Bertuccelli
Safety Manager
- Regulations & Standards
- Machine Safeguarding Devices
- Safety at Winders
- Safety at Slitter-rewinders
- How to Handle the Slitting System Safely
- Safety Procedures During Maintenance
- Do's and Don'ts
- Session 3 - Sessions for specialists
The following two sessions will run parallel to one another.
- Session 3/A - Electronics:
Functioning Fundamentals
Speaker:
Fernando Barsacchi
R&D Manager - Automation
- Electronic and Control Fundamentals
- Technology & Functions
- Functioning Logic:
- Taper
- Draw
- Defect Management
- Soft Start
- Nip Control
- Tension Control: Load Cell Control System
- PID Controls
- Communication Networks: Profibus, Ethernet, MPI
- Session 3/B - Mechanics:
Maintenance & Slitting Systems
Speaker:
Domenico Cecchini
A.Celli International Inc.
- Maintaining Component Performance & Reliability
- Troubleshooting: What to do when the machine is down
- General Guidelines for Maintenance
- Knife Series: PC 130, Slitto, Slitto-Motor
- Defining knife set-up
- Knife Life Management: Blade sharpness, blad sharpening
- Blade Run-out and Vibration
- Understanding Side Load & Blade Overlap (Practical demonstrations with test bench)
- A focus on bearings: Assembling, disassembling, maintenance and lubrication
- Practical demonstration
|
 |
|
|
|
